White Sidewalls Tire Stickers, Permanent - Raised Rubber (14" to 20")

Sizes

Each tire diameter corresponds to a different whitewall size. The table below shows in detail the dimensions of each version (inner diameter and outer diameter of the whitewall), in order to check that the final rendering will meet your expectations. To suit all your needs, we can customize dimensions, do not hesitate to contact us for a quote!

Application Instructions

• Above all, do not attempt installation on a vertical tire directly on the vehicle: remove your wheels in order to work on a flat surface. It is important to install on a complete wheel and not on a single tire. You risk damaging the whitewall with the tire machine, and it is very difficult to precisely center the whitewall on a deflated or bare tire.
• Clean the tire sidewall thoroughly with acetone or brake cleaner, until no dirt or oil is picked up with the rag. If your tire is not new, don't hesitate to use light sandpaper to roughen surface. This step is crucial to guarantee long term durability. Repeat this step as many times as necessary.
• Gently clean the back of the whitewall with acetone of brake cleaner.
• Accurately center the whitewall on your tire. You can immobilize it with masking tape or similar adhesive.
• Apply FleXement adhesive on the backside of the whitewall then glue it to the tire, applying pressure with your fingertips for 30 seconds. Always work in small sections of 5 to 10 centimeters at a time, constantly checking the centering.
• Once fully applied, allow the whitewall to rest for five minutes, then gently remove the transparent transfer film. Check that the edges are perfectly glued. Do not hesitate to add glue during this step, to perfectly seal the edges.
• Once all edges are sealed, allow the whitewall to sit for a minimum of one hour before mounting the wheel back to the car (12 hours ideally before driving).
• Send us your pictures !

Application Video